Headplay Mini HDMI Lead
What were the Headplay design engineers thinking???
The Headplay HD 7″ Headset picture looks absolutely stunning when fed with a HDMI source, but the lack of clearance with the connector … Read more...
Electronics | Amateur radio | Nerdy Stuff
What were the Headplay design engineers thinking???
The Headplay HD 7″ Headset picture looks absolutely stunning when fed with a HDMI source, but the lack of clearance with the connector … Read more...
I’m not exactly sure how this happened, it wasn’t a propeller, but one of the ZTW 12A ESCs was nicked by something as it struck a tree.
Comparing it … Read more...
If you normally need to wear glasses, then rest assured, this is no problem with the Headplay HD 7″ headset.
Picture are worth 1,000 words.
It’s much easier to insert … Read more...
Ripped the SMA antenna connector off your EzUHF receiver in a crash?
It probably looks like this on the solder side:
Components side:
Whilst the SMA jack fitted … Read more...
Took delivery of a Headplay HD FPV headset, and not along after, took it apart.
As you do!
To help with splitting the two halves, hold the switch panel … Read more...
If you’re wearing a FPV headset, goggles, or perhaps have a ground station being powered off a lipo battery you’ll want a low volts warning, but not a loud ear-splitting … Read more...
Displaying RSSI on the micro MinimOSD can be achieved without adding the extra wire between it and the FrSky D4R II receiver’s signal pin 2 (used in CPPM mode).
It’s … Read more...
Here we take a look inside the FR632 5.8 GHz diversity 32 Channel Auto Scan LCD A/V Receiver obtained from the Hobby King AU Warehouse for just under AUD$75.
The Naze32 Flight Controller has a “lost model beeper” output, which looks like this on the schematic diagram:
We can see the beeper output is an open collector transistor, … Read more...
Park Rangers in Africa are using a DJI Phantom to herd pesky elephants away from farmers crops.
Originally aired on ABC-TV News 24 on Wednesday 20-5-2015.
🙂
It appears to be a common problem – the Xiaomi Yi action camera’s lens has been incorrectly preset in the factory.
I’m guessing the Chinese assembly workers set the focus … Read more...
To increase 5.8 GHz FPV range and minimise receiver dropouts, a broadband microwave LNA (Low Noise Amplifier) is assembled and tested.
Whilst you could use a gain antenna like a … Read more...
Micro MinimOSD is a tiny On-Screen Display board that works with the Naze32 flight controller and came from Buzz Hobbies in Perth.
First thing to do was solder up … Read more...
Following on from the prototype FPV microphone preamplifier assembled on Veroboard, a double-sided PCB was designed in DipTrace and the gerber files were sent to iTead studio, where 10 … Read more...