Hi all
Our old 28 MHZ beacon transmitter has died,it is an old Icom transciever.Mike ZL3MF will repair it if its possible.We were looking to replace it with a xtal controled transmitter as if there is a power cut it restarts on default frequency.So we are looking for sugestions or a low power exciter unit that can be the bassis of a ZL3TEN rebuild.
Thanks Ross
Replacement transmitter required for ZL3TEN
Re: Replacement transmitter required for ZL3TEN
Hi Ross
Have a yarn with Simon ZL4PLM hes normally on 705 local mobile lives out at West Melton
Have a yarn with Simon ZL4PLM hes normally on 705 local mobile lives out at West Melton
-
- Frequent Poster
- Posts: 199
- Joined: Mon Dec 28, 2009 6:10 am
- Location: Palmerston North En Zed
- Contact:
Re: Replacement transmitter required for ZL3TEN
Hi. I have xtal ovens and can retune a tait T182c to 10m if your interested. upto 25 watts should not be a problem. You will need a xtal tho..
Mark.
Mark.
Re: Replacement transmitter required for ZL3TEN
Let me know what the crystal requirements are. I am the custodian of the CW Ops QRP club crystal stash (currently around 1500 rocks). It is surprising how often we have something close enough that it can be pulled onto frequency.
http://www.users.on.net/~zietz/qrp/webx ... p_Page.htm
73
John VK4TJ
http://www.users.on.net/~zietz/qrp/webx ... p_Page.htm
73
John VK4TJ
Re: Replacement transmitter required for ZL3TEN
Thanks Guys,will discuss these options with 3NW and 3MF.The Christchurch VHF Group will be gratefull for all help.
Re: Replacement transmitter required for ZL3TEN
Ops better try to put brain into gear we are,
The Christchurch VHF Dx Group.
The Christchurch VHF Dx Group.