Feed through capacitors...

[VK2XV]

Looking for feed through caps (bulkhead) about 1000pF.

They seem to be fairly expensive at around $6 - $12 ea on eBay (plus postage).

Farnell/Element14 have them for about $9 for Qty 10 (plus $12 postage).

Any cheaper sources ?

[ZL2WHO]

I have some tucked away in the workshop, If your not after big Qtys. id be happy to send you some.

Mark.

[VK2XV]

I have some tucked away in the workshop, If your not after big Qtys. id be happy to send you some.

Thanks Mark. I need just one ASAP and so I have bitten the bullet and ordered a couple from EL14 (delivered tomorrow).

But thanks for the offer.

Still curious to know if there is a cheaper source somewhere...

[VK4TI]

""
Still curious to know if there is a cheaper source somewhere..
.""


I got mine from a solar shop that went broke ages ago , very cheap then

[VK2JDH]

Looking for feed through caps (bulkhead) about 1000pF.

They seem to be fairly expensive at around $6 - $12 ea on eBay (plus postage).

Farnell/Element14 have them for about $9 for Qty 10 (plus $12 postage).

Any cheaper sources ?

Rocky have some, but not at the value are wanting.

https://www.rockby.com.au/SearchresSql_ ... chkey=feed

[VK2XV]

Thanks all.

This is the type of FT cap I am interested in...

42415385.jpg (3.11 KiB) Viewed 1946 times

I see these used for power supply feed pins for RF preamplifiers and the like.

Given the price of those little ceramic feedthrough caps maybe $8 or so is about it for this type...

[ZL2WHO]

10x for about $9... Cheap as Chups mate. Seller also has others listed.
eBay item number:
Copy and paste into ebay search. 281423864069

[VK2XV]

10x for about $9...

Thanks Mark - I grabbed a 10x lot. Doesn't look like they come with nuts - hopefully I can squirrel out ones that fit...

[VK3ALB]

Thanks Mark - I grabbed a 10x lot. Doesn't look like they come with nuts - hopefully I can squirrel out ones that fit...

You could always solder them to the shield

[VK2XV]

You could always solder them to the shield

Could do for internal stuff - but I want to use them as power feeds into an aluminium die-cast box.

[VK3BJM]

Steve,

I've just checked one that I have - it has a 1/4 inch 28 TPI thread, which is a common UNF thread size. Any decent tool or bolt shop should have - or be able to get for you - a tap at that size. Then you can tap the die-cast box and screw them in, good and proper. You'll need a 5.5 mm drill bit for the hole to be tapped - even Bunnings will have these...

And to remove any uncertainty, take it into the decent tool or bolt shop and get them to confirm the thread size (if you don't happen to have a thread gauge yourself, of course).

73,
Barry
VK3BJM

[VK2JDH]

And to remove any uncertainty, take it into the decent tool or bolt shop and get them to confirm the thread size (if you don't happen to have a thread gauge yourself, of course).

73,
Barry
VK3BJM

Bunnings have male and female thread gauges in their bolt isle

[VK2XV]

Thanks - I have a tap and die set. I'll see what's what when they arrive.