Hi All..
Is there a way to put in say "VK" in the database section so you can just watch for Australian Spots...without having to display the map.
I know you can put in a specific callsign but can you put in VK in general...
You can do this using clusters for CW, which can be a big help...
John
WSPR specific Prefix
Re: WSPR specific Prefix
Hi
I don't think you can. I've tried previously with no success
73
Iain
I don't think you can. I've tried previously with no success
73
Iain
73
Iain Crawford - VK5ZD
Munno Para West, SA - PF95ih
Iain Crawford - VK5ZD
Munno Para West, SA - PF95ih
Re: WSPR specific Prefix
I just had a play and sorting by Grid might do what your after...
I tried a few wildcards like VK#, VK$, VK%, VK& but no banana!
Cheers
I tried a few wildcards like VK#, VK$, VK%, VK& but no banana!
Cheers
Re: WSPR specific Prefix
I dont think you can. But for VHF band at 2m and above this would be very handy.
It would be good to be able to keep the map refresh on Australia ony.
And to have the database spots show, say VK-ZL spots only etc.
A site suggestions that could be forwarded to the WSPRnet webmaster, along with ability to have maps for 70 and 23 cm etc.
It would be good to be able to keep the map refresh on Australia ony.
And to have the database spots show, say VK-ZL spots only etc.
A site suggestions that could be forwarded to the WSPRnet webmaster, along with ability to have maps for 70 and 23 cm etc.
Re: WSPR specific Prefix
You can centre the map on your location. That helps quite a bit, especially when zooming in.
Alan VK3DXE
QF21nv
QF21nv