DCW2004B Mast Head sequencer CIRCUIT

Related discussion about towers, masts, and transmissions lines
Post Reply
VK4UH
Forum Diehard
Posts: 256
Joined: Wed Apr 14, 2010 12:26 am

DCW2004B Mast Head sequencer CIRCUIT

Post by VK4UH »

Hi there
Does anyone have a circuit for the SSB Electronics Mast Head Preamp SEQUENCER Model DCW-2004B?

This same control box/ Sequencer is used with the 6m 2m and 70 cms Mast-Head preamps.

I have blown a transistor in mine which activates the linear.

The company provide comprehensive documentation for the pre amps including circuits, board layouts and parts lists but NOTHING for the sequencer itself.
There is only the hook-up information.

I contacted SSB Electronics in Germany and was told that they will not provide technical documentation for current products.

A strange way to conduct customer support in my view.
posting.php?mode=post&f=44#
Kevin VK4UH Brisbane
vk4uh@wia.org.au
Kevin (KJ) VK4UH
Brisbane
VK5PO

Re: DCW2004B Mast Head sequencer CIRCUIT

Post by VK5PO »

Hi Kevin.
I know it is not any help in your particular situation, But I built my own sequencer for my 6 m EME set up.

Bench tests look great, and it probably cost around $20-30 to build. I included a "fail-safe" third relay for extra
protection.

components are a few 100uf el. caps, a pair of op amps, (741's) several carbon resistors, two variable resistors and suitable relays.
One relay is a fast switcher, the second "slow" . lna supply rail is also switched out on the "fast" second relay pole
Mounted on "vero" board, it will protect my 18 db lna, the coaxial relays easily handle the 1kw of RF I am allowed to use on six metres.

I can draw you a "circuit" if you get desperate Kevin!
good luck.

John
VK4UH
Forum Diehard
Posts: 256
Joined: Wed Apr 14, 2010 12:26 am

Re: DCW2004B Mast Head sequencer CIRCUIT

Post by VK4UH »

Thanks John
Im still keen to repair the one I have however.

I have traced out the active output which is faulty and located the faulty device but have no idea heat it actually is (was)

A small smd 3/4 lead device

I don't know if it is a FET or NPN PNP transistor
_________
It is marked:- | BL |
| POd |
__________

Can you or anyone reading this identify these markings?

Kevin VK4UH Brisbane
Kevin (KJ) VK4UH
Brisbane
VK4JMC

Re: DCW2004B Mast Head sequencer CIRCUIT

Post by VK4JMC »

Kevin,
Perhaps his might help
Marking of electronic components, SMD Codes BL, BLQ. Datasheets ...
www.s-manuals.com/smd/bl
Marking of electronic components, SMD Codes BL, BLQ. Datasheets 2SB1561, Si1469DH.
Post Reply