AngleLinear PA 50 (Lunar Electronics)

[VK6OX]

This is a bit of a long shot I know, but back in the late 70s I acquired a 6m preamp which was manufactured by Chip Angle and sold by Lunar Electronics (Lou Ancieux). It's a simple preamp in a small enclosure (roughly 2" x 1.5" x 0.5") and I would love to get hold of any specs/cct schematic which I have long since lost. Perhaps one of you 6m ops out there can help!

Thanks in advance.

[VK5TM]

Try contacting the manufacturers, they are still around:

http://www.anglelinear.com/

[VK3ZAZ]

This is a bit of a long shot I know, but back in the late 70s I acquired a 6m preamp which was manufactured by Chip Angle and sold by Lunar Electronics (Lou Ancieux). It's a simple preamp in a small enclosure (roughly 2" x 1.5" x 0.5") and I would love to get hold of any specs/cct schematic which I have long since lost. Perhaps one of you 6m ops out there can help!

Thanks in advance.

Send email to Louis Anciaux
WB6NMT
HL9UH
KG6UH
Now
HP3TA Panama
Louis N. Anciaux
Apdto 0413-00027
Boquete, Chiriqui 41300027
Panama
QSL: HP3TA, KG6UH
Email: zamialouis@gmail.com

The PA50 brilliant amp was removed from its box and fitted inside my TS670 between the first stage coupling transformers and produced -135 dbM for 12dB SINAD
in a TS670 and zero phase noise and coupled with a 12dbd 11 el 50 foot yagi, produced the VK EME 2xCW DX record that has stood the test of time.
I think it uses a U309 or U310.

Says a lot for oldies and goodies. does it not.
Like the TE systems amp...
good luck.

[VK3ZAZ]

This is a bit of a long shot I know, but back in the late 70s I acquired a 6m preamp which was manufactured by Chip Angle and sold by Lunar Electronics (Lou Ancieux). It's a simple preamp in a small enclosure (roughly 2" x 1.5" x 0.5") and I would love to get hold of any specs/cct schematic which I have long since lost. Perhaps one of you 6m ops out there can help!

Thanks in advance.

hi Andy
used them in past inside 670 will check have Joel N6AMG prototype ex 9lg somwhere u can have
they are just a u310 two toroids and trimmers
if you got a picture you could fabricate

lou wb6nmt is sk but mike myc is around ask him.

zaz

[VK6OX]

Good grief, I don't know how I got here but anyway I still have my beloved PA-50!