UNILAB KL-450D UHF Base Manual needed

[VK3ZFS]

I have a UNILAB KL-450D UHF base.
Im after a manual for setting up and interfacing to audio ptt mute control ect
I have the prog to prog up EPROMs..just need a service/install manual.

Regards

Frank VK3ZFS

[VK7JG]

Hello Frank.
Talk to Dion VK7DB .
He has a copy of the service manual .

I will email you with what I have .
73
Joe

[VK7DB]

Yes, talk to me, and I will give you a link to download a PDF.

Dion

[VK2AAH]

oooh I feel a warm fuzzy feeling all over! Weren't they a great base station when they first came out? I loved working on them and if only they didn't keep going through receivers (as in business, not RF) & new owners they would have become an institution in LMR in Australia... take good care of it!

Cheers


Richard
VK2AAH

[VK2GX]

Hello All,
Our local radio club has a Unilab repeater which we are trying to setup on 70cm. The unit has been re-configured for 70cm and the timeout set for 3 minutes. What we are currently working on is the CW identification for the repeater. Just wondering if any has the pin connections for the 24 pin Centronics socket located on the rear of the unit?
Thanks,
Paul VK2GX

[VK3ALB]

Sect 4.pdf

(1.12 MiB) Downloaded 108 times

here you go, hope it helps

[VK2GX]

Thanks Lou,
I am I correct in assuming that the external socket on the rear of the KL-450 unit is referred to as CN24D, that is the pin connection table in the left hand column?
Just trying to determine the pin connections for a CW ident unit, so COS, PTT and tx audio which I am assuming are Pins 16, 14 and 1 & 24 for the tx audio?
Regards,
Paul VK2GX