I have a UNILAB KL-450D UHF base.
Im after a manual for setting up and interfacing to audio ptt mute control ect
I have the prog to prog up EPROMs..just need a service/install manual.
Regards
Frank VK3ZFS
UNILAB KL-450D UHF Base Manual needed
Re: UNILAB KL-450D UHF Base Manual needed
Hello Frank.
Talk to Dion VK7DB .
He has a copy of the service manual .
I will email you with what I have .
73
Joe
Talk to Dion VK7DB .
He has a copy of the service manual .
I will email you with what I have .
73
Joe
Re: UNILAB KL-450D UHF Base Manual needed
Yes, talk to me, and I will give you a link to download a PDF.
Dion
Dion
Re: UNILAB KL-450D UHF Base Manual needed
oooh I feel a warm fuzzy feeling all over! Weren't they a great base station when they first came out? I loved working on them and if only they didn't keep going through receivers (as in business, not RF) & new owners they would have become an institution in LMR in Australia... take good care of it!
Cheers
Richard
VK2AAH
Cheers
Richard
VK2AAH
Re: UNILAB KL-450D UHF Base Manual needed
Hello All,
Our local radio club has a Unilab repeater which we are trying to setup on 70cm. The unit has been re-configured for 70cm and the timeout set for 3 minutes. What we are currently working on is the CW identification for the repeater. Just wondering if any has the pin connections for the 24 pin Centronics socket located on the rear of the unit?
Thanks,
Paul VK2GX
Our local radio club has a Unilab repeater which we are trying to setup on 70cm. The unit has been re-configured for 70cm and the timeout set for 3 minutes. What we are currently working on is the CW identification for the repeater. Just wondering if any has the pin connections for the 24 pin Centronics socket located on the rear of the unit?
Thanks,
Paul VK2GX
Re: UNILAB KL-450D UHF Base Manual needed
here you go, hope it helps
Lou - VK3ALB
Being right doesn't excuse bad behaviour
Being right doesn't excuse bad behaviour
Re: UNILAB KL-450D UHF Base Manual needed
Thanks Lou,
I am I correct in assuming that the external socket on the rear of the KL-450 unit is referred to as CN24D, that is the pin connection table in the left hand column?
Just trying to determine the pin connections for a CW ident unit, so COS, PTT and tx audio which I am assuming are Pins 16, 14 and 1 & 24 for the tx audio?
Regards,
Paul VK2GX
I am I correct in assuming that the external socket on the rear of the KL-450 unit is referred to as CN24D, that is the pin connection table in the left hand column?
Just trying to determine the pin connections for a CW ident unit, so COS, PTT and tx audio which I am assuming are Pins 16, 14 and 1 & 24 for the tx audio?
Regards,
Paul VK2GX