http://www.vk3bq.com/2014/12/04/icom-ic ... t-control/
i battled with the IC9100 and WSPR for a long time until I found this software to drive the Cat commands called CTA7200 to RTS using a virtual com port. read about it above..
works a treat on WSPR and other software and the IC9100 ,... it might help others too.. thanks
Cat to RTS virtual Serial Port for IC9100/IC7100 WSPR
Re: Cat to RTS virtual Serial Port for IC9100/IC7100 WSPR
Thanks for bringing that up Andrew. A bit of rigmarole with the unsigned driver, but I followed the steps on the W's web site and finally got there with Win8. So far tested OK with WSPR on my IC-7600 ... now I have the audio and CI-V PTT via the one USB port from the computer to the radio.
73,
73,
Bob, ZL1RS in the Bay of Islands at RF64vs
Re: Cat to RTS virtual Serial Port for IC9100/IC7100 WSPR
Noted else where others having trouble with 9100 USB cat port.
I found good quality short USB cable helps and others have used a powered USB hub to overcome connection problems.
The ICom remote CAT software seems to work ok with my 9100 after I fixed the USB connection. I just have to work out how to remote it to my Iphone now so I am looking for a APP.
Cheers
I found good quality short USB cable helps and others have used a powered USB hub to overcome connection problems.
The ICom remote CAT software seems to work ok with my 9100 after I fixed the USB connection. I just have to work out how to remote it to my Iphone now so I am looking for a APP.
Cheers
Regards
Rob
VK1KW
Rob
VK1KW