9913 Coax

[VK3BGS]

Looking for a supplieer of N connectors for 9913 coax.
These require a larger center pin.
Tried my last source and no longer available.
Even the local manufacturer no longer makes them due so low demand.
Woud prefer a local source but may be forced to look overseas or change cable type.

73
de Denis

[VK7JG]

Hello Denis .
Connectors for LMR400 should do the trick .\

I notice that Mini Kits have supplies otherwise Rojone can supply .

In the past I have used RG213 connectors and cut off two of the centre wires . It might sound a little crude bit will get you out of trouble.

73
Joe
VK7JG

[VK4GHZ]

Connectors for LMR400 should do the trick

Never knew that. You learn something everyday!
This AMPHENOL N-connector listed on Element 14 certainly backs this claim up.

In addition to Joe's suggestions;
RF Shop (Brisbane)

Radio Specialists (Adelaide)

If in no hurry, from China RF Supplier.
By a spare or two. I've had one dud N-SMA adapter from this lot. (The thread on the N side was not quite right)
But then again, I've ordered probably close to 100 connectors and adapters from them, and only had the one dud.

[VK3BQ]

Been happy with mini kits connectors. As above.

http://www.minikits.com.au/components/c ... connectors

[VK4TI]

Looking for a supplieer of N connectors for 9913 coax.
These require a larger center pin.
Tried my last source and no longer available.
Even the local manufacturer no longer makes them due so low demand.
Woud prefer a local source but may be forced to look overseas or change cable type.

73
de Denis

find a local supplier with a Madisons account (Brisbane head office) or go direct to the rf shop in Brisbane , they have online

[VK3BGS]

Thank you to all for your information, very much appreciated.
Found a supplier.

73 de Denis VK3BGS

[VK2ZTV]

Which supplier did you end up with, as I have some 9913 coax which is in need of connectors.

73's
Peter VK2ZTV

[VK2ZRH]

Me too.

73, Roger Harrison VK2ZRH

[VK3BGS]

Went to Radio Specialists in Adelaide.
Brian was very helpful indeed.
Also ordered a crimper as well.
Have a look at Adam's post in this thread for web site details.

Denis