VK Logger Ham Radio Forum Archive

Brenden
looking at your site I see opportunity for wire , mag loops and some great dx , perhaps agreeing to the convenant was not a good idea or is that now defunct ?
personally some wire beams and a decent loop would get your dx heard imho

hearing it well enough 220 cwusb

I added a substanual ferrite cored choke to my 43ft vertical and stopped some problems , didnt help most of the noise though

"VK4GJW"I probably should have described my antenna better. It is an Inverted V 40Mtr dipole, with the centre at 10Mtrs above ground. It is coax fed, with a 1:1 balun at the apex. So being coax fed it is not entirely isolated from gound, all be it that that ground connection is via the coa...

"VK3BQ"this is an interesting read. someone made a lot of money on the demise.

Oh snap

Dicks could be running fine read this http://www.smartoffice.com.au/business/ ... pears.aspx as an explanation about corporate raiding
Damn shame

You just keep living down there old boy , we have enough curmudgeon of our own

Thanks for making the effort although conditions did not help , your kindness in leaving the gear means the future attempts will be easier and more often

It's possible to obtain wireless through telecom on the island for a nominal amount , perhaps ask your hotel ?

Go to your local cheap shop and source a white cutting board , test a bit in the micro just in case and cut it to your needed size , some ss screws and your done , the bunnings boom will be fine , I have glued and screwed white cutting board up to large 6m beams with good success

It can help and once a pattern established gets much quicker remembering the rx is swung through an arc on tight filters

"VK4WDM"Hi Gordon

OK, so this needs a brain transplant. Any offers to do the job?

73

Wayne VK4WDM"

Ask and you shall receive

"ZL3MF"looks right acording to the guide , did you reboot the router ? if there is a common fault try again save and reboot[/quote] Hi yes have done all of that also checked for firmware update even put back to factory defaut and started again....no cigar. Cheers Mike ZL3MF"" htt...

looks right acording to the guide , did you reboot the router ?
if there is a common fault try again save and reboot

There was a small company making water driven masts in Brisbane not long after I got on air three or more decades ago , kinda expensive as I recall , not hard to make but air is a better medium imho
Simple enough to make a basic trebuchet with limit stops , cheap effective

"""VK4UH"How much torque can steppers generate - or were you thinking geared? Kevi "" steppers can produce huge torque or can be geared further I have some in use for turning a massive vacuum cap direct drive have a read http://www.geckodrive.com/support/step-motor-basi...

a quick google suggests a stepper and ardiuno would be possible

http://people.physics.anu.edu.au/~dxt10 ... s/Rrad.php
suitable vertical with a well built ground system will reach 90% efficiency ?

"VK3ALB" I think he already eliminated the plug pack by substituting a 12V battery. Is there another mains supply?"" Getting specific information about the fibre interface is currently difficult but often there are various internal voltages and and ocilators operating so obtainin...

Without some real facts I have to call b/s most probable