Nextion HMI

Universal K3NG Rotator Controller System

Update 11-Feb-2021:

• NX8048K035 5.0″ Firmware Update

 

A universal rotator controller project based on Anthony Good’s popular K3NG rotator controller.

This project features a Teensy 3.2 microcontroller and Nextion Enhanced HMI with custom user interface.

• Yaesu G-800DXA (and G-1000-DXA, G-2800-DXA) azimuth rotator control

• Yaesu G-800DXA (and G-1000-DXA, G-2800-DXA) PWM speed voltage output

• Az analogue potentiometer input

• El analogue potentiometer input

• Yaesu G-5500 compatible for CW/CCW/Up/Down control

• PWM motor driver for linear actuator elevation control

• i2c extender for remote sensors via cat5

• Spare cat5 pair pads available

• Audible alert output

• Teensy RTC battery connection

• GPS serial data pass-through (genuine FTDI chip) to USB for time-syncing PC

• Four NO push-button switch inputs with pull-ups

 

Universal Main controller board

 

 

 

 

 

 

 

 

 

 

Rear Connectors

 

 

 

 

 

 

 

Development Remote Unit at the end of a 30m (100ft) run of cat5 cable.… Read more...

Nextion for K3NG Rotator Controller Videos

A series of videos demonstrating the VK4GHZ Nextion for K3NG Rotator Controller

Part 1 – Basic Az system

Part 1 looks at a basic azimuth-only system and introduces you to some of the functionality offered.

 

Part 2 – Elevation

Part 2 introduced elevation functionality and adds a decimal place to Az & El readings.… Read more...

Degrees Symbol for K3NG Rotator Controller Nextion – 2

The K3NG rotator controller is extremely well supported by the author, Anthony Good, K3NG.

Since the last bug report, one issue, easily overlooked by those not entirely familiar with the Nextion display,  has been identified that can easily cause grief,

Along with creating fonts with iso-8859-1 encoding, make sure when setting up your Nextion HMI project in the Nextion Editor, that the character encoding type is also set to iso-8859-1.… Read more...

Degrees Symbol for K3NG Rotator Controller Nextion

This video shows how you can get the degrees symbol ° on the K3NG Rotator Controller’s Nextion touchscreen.
Applies to version rotator controller v20.06.26.02.
 
It’s a simple matter of editing four lines of code in the main .ino file.
 
In the normal world “0xF8” would be the correct way to address the ° symbol, but not with these damn Nextions!
Read more...

Eltek Flatpack2 HE 48V/2000W Controller

An Eltek Flatpack2 HE 48V/2000W rectifier is being used as the power supply for a 23cm 600W LDMOS Power Amplifier project.

This touchscreen controller has been developed to control the Flatpack2 HE 48V/2000W, and display its data.

Read more...